Model: Onan QG5500 EVAP - A063B613 I 5.5HGJAE-6757 | 120/240V | Watts - 5500W GASOLINE | RPM - 2400 | Circuit Breaker: 30A 2-POLE
✅ IN STOCK - 3-5 DAY LEAD TIME
Cummins Onan QG5500 Gasoline EVAP Commercial Mobile - 120/240V
Evaporative spec: All model year 2011 and later spark-ignited small off-road engines rated at equal to or less than 19 Kilowatts, and equipment utilizing such engines must meet the evaporative emission requirements as specified in Title 13, California Code of Regulations, Chapter 15, Article 1, 40 CFR Part 1054 §1054.112, and 40 CFR Part 1060. EVAP capable units are required when the genset is the only engine attached to the fuel tank. For applications where the vehicle propulsion engine is connected to the EVAP system and the genset is not connected to the EVAP system, EVAP capable units are not required.
Features and Benefits:
- Integrated hydraulic pump option
- Quietest and lowest vibration generator set in its class
- Integrated housing design
- Enclosed muffler for ease of installation
- Self-diagnostic capability to simplify troubleshooting
- Runs two ACs
- Digital regulation for voltage stability as loads change
- 2-year limited warranty
QG5500 EVAP Specifications
Physical Dimensions
- Weight: 290 lbs
- Size (L×W×H): 33.6" × 22.2" × 16.7"
- Sound: 66 dB(A) at 10-feet, half-load
Typical installation will further reduce sound level.
Alternator
- Design: Cummins Onan revolving field, AC, 2-pole self-excited, two bearing design
- Insulation system and temperature rise: Meets ANSI/RVIA-EGS-1-1998 and CSA TIL RV-06 requirements.
- Cooling: Direct drive centrifugal blower, cast aluminum housing for excellent heat transfer.
- Rotor: Laminated electrical steel assembly press-fitted to shaft, balanced. Heavy insulated copper wire windings; optimized air gap for improved waveform and motor starting.
- Stator: Laminated electrical steel assembly, skewed for better waveform; heavy insulated copper wire windings.
- Excitation: Capped, digital voltage regulation
- DC brushes: Electrographite; long life
- Bearing: Double-sealed, pre-lubricated ball bearing
-
Hydraulic pump:
- Fixed displacement gear pump, 1.5 Gal/min at 2500 psi
- A generator set with a hydraulic pump is rated with the pump idle
- When using a non-Cummins pump supplied by the customer, the hydraulic pump shaft seals must be capable of operating in a temperature environment of 225° F to 250° F. Seal failure will result in equipment damage
Engine
- Configuration: Cummins Onan 4-cycle, OHV, 90-degree V-twin
- Displacement: 39.8 cubic inches
- Maximum Power: 11.6 HP at 2400 RPM
- Starting System: Remote, 12 V, 3-wire, negative ground automotive type starter with steel pinion and ring gear, automatic start disconnect, connector for remote start cable, start-stop rocker switch mounted on set control
- Ignition System: Electronic magneto type with resistor plugs
- Oil Capacity: 2.0 quarts
Fuel Consumption (GASOLINE)
- No Load: 0.35 GPH
- Half Load: 0.6 GPH
- Full Load: 0.95 GPH
Operating Temperature Range
- Minimum: -20°F (-29°C)
- Maximum: 120°F (49°C)
Warranty
2-Years or 2,000 Hours (whichever occurs first) Limited Warranty. Parts and labor will be covered for warrantable failures except routine maintenance during two years warranty coverage period.
Availability
In Stock - Call Buckeye Power Systems today for a shipping quote and get your commercial mobile operation powered up.
Experience the reliability and performance that has made Cummins Onan the preferred choice of commercial mobile operators.